
E-SATA
I/O port installation
BLUE
BLACK PUEPLE
YELLOW
BROWN
RED
10
8
6
4
2
9
7
5
3
1
GREEN
KEY
ORANGE
N.C.
GND+H.S. TUBE
HD AUDIO
4
1
5
9
USB3.0
USB USB EARMIC
SATA
USB3.0 to USB2.0 convertor
RED
WHITE
GREEN
BLACK
VCC
D-
D+
GND
RED
WHITE
GREEN
BLACK
KEY
VCC
D-
D+
GND
PSU tray installation
Loosing four thumb screws to
remove the PSU mounting
bracket.
Assembling the power supply
with PSU mounting bracket, and
push in gently.
Fasten four thumb screws onto the
case to secure.
VGA card pillar installation guide
1
2
3
4
C50.V2120.02E-2
Remove 120mm fan cover
Loosing four screws to remove
the 120mm fan cover in order
to install the optional kit
Remove front fan &
air filter
Fan adjustable device
H
L
Cable management note
Use cable clamp to
tidy up the cables.
Insert PCI card holder/A Place PCI card holder/B for thick VGA card
OPTIONAL KIT:
120mm fan module
* To remove clamp,
release the cable clamp
by using tweezers.
Follow the arrow to remove the
front fan & air filter
Release brake
Follow the arrow to remove the
bottom air filter
Follow the arrow to
release brake
Remove air filter
Change door from right-side-open to left-side-open,
visit www.lian-li.com for installation guide
Notice:
ODD installation
Release the mounting bracket
Push the CD-ROM into the
ODD module
Close the bracket.
Just press plastic handle
POWER SW
RESET SW
POWER
LED
H.D.D LED
SPEAKER
WHITE
GRAY
WHITE
BLUE
WHITE
NC
GREEN
WHITE
ORANGE
BLACK
NC
NC
RED
GROUND
PWR
GROUND
Reset
PLED-
PLED+
IDE_LED-
IDE_LED+
Speaker
+5V
Cable installation guide
Vent for USB3.0 cable
Access to rear I/O port
Kommentare zu diesen Handbüchern